Cut-off (electronics)

In electronics, cut-off is a state of negligible conduction that is a property of several types of electronic components when a control parameter (that usually is a well-defined voltage or electric current, but could also be an incident light intensity or a magnetic field), is lowered or increased past a value (the conduction threshold). The transition from normal conduction to cut-off can be more or less sharp, depending on the type of device considered, and also the speed of this transition varies considerably.

Cutoff values

Diodes

Copper oxide diode:
Diac:
Germanium diode: apx 0.3 V; varying with temperature
Schottky diode:0.15–0.45 V
Selenium diode:
Silicon diode: cutoff occurs when Vf falls below apx 0.7 V. The exact voltage varies with temperature.
Thermionic diode: cutoff voltage depends on device design. Much higher than for silicon devices.
Zener diode: reverse cutoff defined by diode voltage rating. Forward cutoff apx 0.6 V.

Transistors

BJT: Depends on the configuration
Germanium transistor: apx 0.2 V, varying with temperature
MOSFET:
Silicon transistor: apx 0.6 V, varying with temperature.
TRIAC:

Valves

Triodes: triodes cut off when applied grid bias is too low. This will be a negative voltage under ordinary conditions.
Tetrode, pentode etc.: There is some degree of interaction between the grids, and values will vary from one device to another. Anode voltage also affects cutoff voltage.

Remote cutoff

A vacuum tube (such as a pentode, but also sometimes triodes, hexodes, heptodes and so on) with its control grid given a helix with a variable pitch can be made to operate with more negative grid voltages, with reduced amplification, before it is completely cut off (i.e. yielding no significant output). This ability to vary the amplification (sometimes called mu) and also the transconductance, is useful in Automatic Gain Control (AGC) stages of radio receivers. Devices with this characteristic are called remote-cutoff or variable-mu or super-control types.

Sharp cutoff

With a normal control grid arrangement, a vacuum tube will have close to a square-law relationship between input (grid) voltage and output (anode/plate) current, with the latter falling sharply to roughly zero. This characteristic is normally required for linear RF and audio uses. Examples; EF86 and 6AK5.

Semi-remote cutoff

A semi-remote cutoff device has characteristics somewhere between a remote-cutoff device and a sharp-cutoff one.

References

External links

This article is issued from Wikipedia - version of the 4/12/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.