Acousto-optic programmable dispersive filter

An acousto-optic programmable dispersive filter (AOPDF) is a special type of collinear-beam acousto-optic modulator[1] capable of shaping spectral phase and amplitude of ultrashort laser pulses. AOPDF was invented by Pierre Tournois.[2] Typically, quartz crystals are used for the fabrication of the AOPDFs operating in the UV spectral domain, paratellurite crystals are used in the visible and the NIR (up to 4 µm) and calomel in the MIR (3-20 µm). Recently introduced Lithium niobate crystals allow for high-repetition rate operation (> 100 kHz) owing to their high acoustic velocity. The AOPDF is also used for the active control of the carrier-envelope phase of the few-cycle optical pulses[3] and as a part of pulse-measurement schemes.[4] Although sharing a lot in principle of operation with an acousto-optic tunable filter, the AOPDF should not be confused with it, since in the former the tunable parameter is the transfer function and in the latter it is the impulse response

Image illustrating the principle of spectral phase and amplitude shaping by an acousto-optic programmable dispersive filter.

Theory of operation

Traveling acoustic wave induces variations in optical properties thus forming a dynamic volume grating.

Pulse shaping

AOPDF is a programmable spectral filter. From signal processing point of view, the AOPDF corresponds to a time-variant passive linear transversal filter with a programmable finite impulse response. Phase and amplitude filtering in the AOPDF is achieved by virtue of birefringent acousto-optic effect and can be represented by a convolution between the amplitude of the input optical signal Ein(t) and a programmable acoustical signal S(t/α) proportional to the electrical signal S(t) applied to the Piezoelectric_transducer (made typically from lithium niobate). Here, α is a scaling factor equal to the ratio of the speed of sound v to the speed of light c times the index difference Δn between the ordinary and the extraordinary waves taken along the propagation axis in the crystal. In the limit of low diffraction efficiency the AOPDF behaves as a linear filter and the small value of the α (typically 10-7) allows for the quantitative control of optical signals with frequencies of tens to hundreds terahertz with electrical signals of tens of megahertz, which are readily produced by commercial waveform generators.

Polarization

Owing to its birefringent nature, the AOPDF is intrinsically polarization-sensitive. Furthermore, polarization of the diffracted wave, created as the result of the interaction between the incident optical wave and the acoustic wave in the crystal, is rotate by 90° with respect to the incident wave polarization. For the single-beam optical input there could be up to 4 beams at the output of the AOPDF: two transmitted (non-diffracted) beams arising from double refraction and (in the presence of a suitable acoustic wave in the crystal) two diffracted beams corresponding to each linear polarization component (ordinary and extraordinary) of the input beam. Typically, ordinary-polarized beam is used at the input and so, only two beams are observed at the output: ordinary-polarized transmitted beam and extraordinary-polarized diffracted beam.

Diffraction efficiency

Spectral intensity of the diffracted wave depends on the spectral intensity of the acoustic wave (which depends, in turn, on the RF power applied to the transducer). Ratio between the diffracted intensity and the input one represents the diffraction efficiency. Maximum diffraction efficiency is limited by nonlinear effects. Linear regime persists up to diffraction efficiencies of about 50%. Total efficiency is altered by Fresnel losses at the input and output faces of the crystal unless anti-reflection coating is used.

Spectral bandwidth

Spectral bandwidth of the AOPDF is defined as a range over which the device can operate. One can distinguish intrinsic bandwidth, which is limited by absorption of the acoust-optic crystal, total device bandwidth, limited by impedance matching between the piezoelectric transducer and the radio-frequency generator, and instantaneous bandwidth defined by maximal simultaneous spectral width diffracted with reasonable efficiency.

See also

References

  1. ↑ I.C. Chang (1992). "Collinear beam acousto-optic tunable filters". Electronics Letters. 28 (13): 1255–1256. doi:10.1049/el:19920793.
  2. ↑ Pierre Tournois (1997). "Acousto-optic programmable dispersive filter for adaptive compensation of group delay time dispersion in laser systems". Optics Communications. 140 (4–6): 245–249. Bibcode:1997OptCo.140..245T. doi:10.1016/S0030-4018(97)00153-3.
  3. ↑ L. Canova; et al. (2009). "Carrier-envelope phase stabilization and control using a transmission grating compressor and an AOPDF". Optics Letters. 34: 1333–5. Bibcode:2009OptL...34.1333C. doi:10.1364/OL.34.001333.
  4. ↑ Forget, Nicolas; Oksenhendler, Thomas (2010). "Pulse Measurement Techniques Using an Acousto-Optic Programmable Dispersive Filter". In Mikhail Grishin. Advances in Solid State Lasers Development and Applications. InTech. ISBN 978-953-7619-80-0.
This article is issued from Wikipedia - version of the 10/18/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.