Facing and trailing

Turnouts facing and trailing. Note that this diagram is for left-hand traffic. For right-hand traffic, invert "F" and "T".

Facing and trailing are terms used to describe railway turnouts (or 'points' in the UK) in respect to whether they are divergent or convergent. When a train traverses a turnout in a facing direction, it may diverge onto either of the two routes. When travelled in a trailing direction, the two routes converge onto each other.

History

In the early history of railways in Britain, when signalling and interlockings were primitive, and staff were inexperienced, facing turnouts were a hazard, because they could switch a train travelling at high speed into a slow speed divergence or dead end. Facing turnouts were therefore banned, except when absolutely necessary. Facing turnouts cannot be avoided on single lines and their crossing loops.

With the widespread availability of electrically interlocked signalling in modern times, the rule against facing turnouts has been relaxed.

Diamond crossings

Fixed diamond crossings (with no moving parts) count as trailing points in both directions, although in very exceptional circumstances such as propelling a train in reverse over fine angle diamond crossings they can derail wagons as they bunch up.

So-called switch(ed) diamonds, which contain two stub turnouts in disguise, count as facing turnouts in both directions and are also known as moveable angles (UK).

Moveable crossings

Fixed V-crossings are trailable in both directions. Moveable crossings are effectively facing in both directions and must be correctly aligned.

Stub switches

Stub switches are effectively facing in both directions and must be correctly aligned.

Double junctions

Double junctions are now configurable in a number of different ways, whereby the number of facing and trailing turnouts vary.

Goods siding

The goods siding on a double line (in the above diagram) uses two trailing points and a diamond. It can be shunted by trains in either direction.

This was widely done in New South Wales, though later on the diamond crossing was replaced with a pair of ladder crossovers; such as:

Railway track layouts

Running lines	Single track Passing loop Double track Quadruple track Crossover

Rail sidings	Balloon loop Headshunt Refuge siding Rail yard Classification yard

Junctions	Flying junction Level junction Double junction Facing and trailing Grand union Wye Switch / turnout / points Swingnose crossing Level crossing

Stations	Railway platform Side platform Island platform Bay platform Split platform Terminal station Balloon loop Spanish solution Cross-platform interchange Interchange station

Hillclimbing	Horseshoe curve Zig Zag / Switchback Spiral

Track geometry	Track gauge Ruling gradient Minimum curve radius Cant Cant deficiency

This article is issued from Wikipedia - version of the 9/5/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.