nohup

nohup is a POSIX command to ignore the HUP (hangup) signal. The HUP signal is, by convention, the way a terminal warns dependent processes of logout.

Output that would normally go to the terminal goes to a file called nohup.out if it has not already been redirected.

Use

The first of the commands below starts the program abcd in the background in such a way that the subsequent logout does not stop it.

$ nohup abcd &
$ exit

Note that these methods prevent the process from being sent a 'stop' signal on logout, but if input/output is being received for these standard I/O files (stdin, stdout, or stderr), they will still hang the terminal.^[1] See Overcoming hanging, below.

nohup is often used in combination with the nice command to run processes on a lower priority.

$ nohup nice abcd &

Existing jobs, processes

Some shells (e.g. bash) provide a shell builtin that may be used to prevent SIGHUP being sent or propagated to existing jobs, even if they were not started with nohup. In bash, this can be obtained by using disown -h job; using the same builtin without arguments removes the job from the job table, which also implies that the job will not receive the signal. Before using disown on an active job, it should be stopped by Ctrl-Z, and continued in the background by the bg command.^[2] Another relevant bash option is shopt huponexit, which automatically sends the HUP signal to jobs when the shell is exiting normally.^[3]

The AIX and Solaris versions of nohup have a -p option that modifies a running process to ignore future SIGHUP signals. Unlike the above-described disown builtin of bash, nohup -p accepts process IDs.^[4]

Overcoming hanging

Note that nohupping backgrounded jobs is typically used to avoid terminating them when logging off from a remote SSH session. A different issue that often arises in this situation is that ssh is refusing to log off ("hangs"), since it refuses to lose any data from/to the background job(s).^[5][6] This problem can also be overcome by redirecting all three I/O streams:

$ nohup ./myprogram > foo.out 2> foo.err < /dev/null &

Also note that a closing SSH session does not always send a HUP signal to depending processes. Among others, this depends on whether a pseudo-terminal was allocated or not.^[7]

Alternatives

• A terminal multiplexer can run a command in a separate session, detached from the current terminal, which means that if the current session ends, the detached session and its associated processes keeps running. One can then reattach to the session later on.

For example, the following invocation of screen will run somescript.sh in the background of a detached session:

screen -A -m -d -S somename ./somescript.sh &

• The disown command is used to remove jobs from the job table, or to mark jobs so that a SIGHUP signal is not sent on session termination.

References

1. "Re: nohup/disown and logout". Zsh.org. 2005-02-07. Retrieved 2009-06-10.
2. Bash Reference Manual. Gnu.org. Retrieved on 2015-04-13.
3. Bash Reference Manual. Gnu.org. Retrieved on 2015-04-13.
4. IBM Knowledge Center. 01.ibm.com (2015-03-26). Retrieved on 2015-04-13.
5. "SSH Frequently Asked Questions". Snailbook.com. Retrieved 2009-06-10.
6. "OpenSSH FAQ". Openssh.com. 2005-09-20. Retrieved 2009-06-10.
7. "Bug 396 – sshd orphans processes when no pty allocated". Bugzilla.mindrot.org. Retrieved 2009-06-10.

External links

• nohup from Solaris's man pages