Tensionless hitch

Tensionless Hitch

A tensionless hitch around a post
Names Tensionless Hitch, high-strength tie-off, No-Knot
Category Hitch
Efficiency 100%
Related Round turn and two half-hitches, Pipe hitch, Klemheist knot, Tugboat hitch
Releasing Non-jamming
Typical use anchor knot
Caveat The anchor diameter should be at least 8X the rope diameter.[1] Also, the hitch will not stay in place without a load.
ABoK 2047[2]

A Tensionless hitch is an anchor knot used for rappelling or rope rescue. Unlike most knots, the tensionless hitch retains a 100% efficiency rating,[3] meaning the strength of the knot is equal to the strength of the rope; it is not a significant stress riser.

Tying

The working end of a rope is prepared by tying a Figure-eight loop, and then clipping a carabiner through that loop.

The rope is then wrapped around a smooth pole, pipe, round beam or tree branch which has a diameter greater than the rope. The rope is typically wrapped 3 to 4 times around the anchor, without crossing. Finally, the working end is attached to the standing part with the carabiner.

An overhand knot may be tied around the standing part before the final wrap around the anchor.[4]

References

  1. "Tensionless Hitch". Knots 3D. Nynix LLC. Retrieved 5 May 2016.
  2. Ashley, Clifford W. (1993) [1944], The Ashley Book of Knots, New York: Doubleday, p. 332, ISBN 0-385-04025-3
  3. Technical Rescue: Rope Rescue Accessed: 11/24/2013
  4. "ANCHORS AWAY: Learn How to Tie a High-Strength Tie-Off Anchor". CMC Rescue. Retrieved 5 May 2016.
This article is issued from Wikipedia - version of the 11/6/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.