STS-82

STS-82

The Hubble Space Telescope being serviced in Discovery's payload bay
Mission type Hubble servicing
Operator NASA
COSPAR ID 1997-004A
SATCAT № 24719
Mission duration 9 days, 23 hours, 38 minutes, 09 seconds
Distance travelled 10,500,000 kilometres (6,500,000 mi)
Orbits completed 149
Spacecraft properties
Spacecraft Space Shuttle Discovery
Payload mass 83,122 kilograms (183,253 lb)
Crew
Crew size 7
Members Kenneth D. Bowersox
Scott J. Horowitz
Joseph R. Tanner
Steven A. Hawley
Gregory J. Harbaugh
Mark C. Lee
Steven L. Smith
Start of mission
Launch date 11 February 1997, 08:55:17 (1997-02-11UTC08:55:17Z) UTC
Launch site Kennedy LC-39A
End of mission
Landing date 21 February 1997, 08:32 (1997-02-21UTC08:33Z) UTC
Landing site Kennedy SLF Runway 15
Orbital parameters
Reference system Geocentric
Regime Low Earth
Perigee 475 kilometres (295 mi)
Apogee 574 kilometres (357 mi)
Inclination 28.4698 degrees
Period 95.2 min
Capture of Hubble
RMS capture 13 February 1997, 08:34 UTC
RMS release 19 February 1997, 06:41 UTC


Left to right - Front: Bowersox, Hawley, Horowitz; Back: Tanner, Harbaugh, Lee, Smith

Space Shuttle program
← STS-81 STS-83 →

STS-82 was the 22nd flight of the Space Shuttle Discovery and the 82nd mission of the Space Shuttle program. It was NASA's second mission to service the Hubble Space Telescope, during which Discovery's crew repaired and upgraded the telescope's scientific instruments, increasing its research capabilities. Discovery launched from Kennedy Space Center, Florida, on 11 February 1997, returning to Earth on 21 February 1997 at Kennedy Space Center.[1]

Crew

Position Astronaut
Commander Kenneth D. Bowersox
Fourth spaceflight
Pilot Scott J. Horowitz
Second spaceflight
Mission Specialist 1 Joseph R. Tanner
Second spaceflight
Mission Specialist 2 Steven A. Hawley
Fourth spaceflight
Mission Specialist 3 Gregory J. Harbaugh
Fourth spaceflight
Mission Specialist 4 Mark C. Lee
Fourth spaceflight
Mission Specialist 5 Steven L. Smith
Second spaceflight

Spacewalks

Mission Objectives

Astronauts train in the Neutral Buoyancy Simulator with a mockup of the HST

The STS-82 mission was the second in a series of planned servicing missions to the orbiting Hubble Space Telescope ("HST"), which had been placed in orbit on 24 April 1990 by Discovery during STS-31. The first servicing mission was done by Space Shuttle Endeavour on STS-61. Work performed by Discovery's crew significantly upgraded the scientific capabilities of the HST and helped to keep the telescope functioning smoothly until the next scheduled servicing missions, which were STS-103 in 1999 and STS-109 in 2002.[1]

On the third day of the mission, Discovery's seven-member crew conducted the first of four spacewalks (also called Extra-vehicular Activities or "EVAs") to remove two older instruments and install two new astronomy instruments, as well as perform other servicing tasks. The two older instruments being replaced were the Goddard High Resolution Spectrograph and the Faint Object Spectrograph, exchanged for the Space Telescope Imaging Spectrograph (STIS) and the Near Infrared Camera and Multi-Object Spectrometer (NICMOS), respectively.[2]

In addition to installing the new instruments, astronauts replaced other existing hardware with upgrades and spares. Hubble received a refurbished Fine Guidance Sensor, an optical device used to provide pointing information for the telescope and as a scientific instrument for astrometric science.[1] The Solid State Recorder (SSR) replaced one of HST's reel-to-reel tape recorders. The SSR provides much more flexibility than a reel-to-reel recorder and can store ten times more data.[1][2] One of Hubble's four Reaction Wheel Assemblies (RWA) -- part of the telescope's Pointing Control Subsystem—was replaced with a refurbished spare.[3] The RWAs use angular momentum to move and maintain the telescope in a desired position. The wheel axes are oriented so that the telescope can provide science with only three wheels operating, if required.[1] Study of the returned mechanism provided a rare opportunity to study equipment that had undergone long-term service (7 years) in space, particularly for the effects of vacuum on lubricants which were found to be in 'excellent condition'.[3]

Mission Results

Joseph Tanner performing maintenance on the Hubble Space Telescope.

STS-82 demonstrated anew the capability of the Space Shuttle to service orbiting spacecraft. Discovery's crew completed servicing and upgrading of the Hubble Space Telescope during four planned EVAs, later performing a fifth unscheduled space walk to repair insulation on the telescope.[2]

HST deployed in April 1990 during STS-31. It was designed to undergo periodic servicing and upgrading over its 15-year lifespan, with first servicing performed during STS-61 in December 1993. Hawley, who originally deployed the telescope, operated the orbiter Remote Manipulator System arm on STS-82 to retrieve HST for second servicing at 3:34 am EST, 13 Feb., and positioned it Discovery's payload bay less than half an hour later.[2]

Relying on more than 150 tools and crew aids, Lee and Smith performed EVAs 1, 3 and 5, with Harbaugh and Tanner performing EVAs 2 and 4. EVA 1 began at 11:34 pm EST, 13 February, and lasted six hours, 42 minutes. One of Hubble's solar arrays was unexpectedly disturbed by a gust of air from Discovery's airlock when it was depressurized, but was not damaged.[2] Lee and Smith removed two scientific instruments from Hubble, the Goddard High Resolution Spectrograph (GHRS) and Faint Object Spectrograph (FOS), and replaced them with the Space Telescope Imaging Spectrograph (STIS) and Near Infrared Camera and Multi-Object Spectrometer (NICMOS), respectively. STIS expected to shed further light on supermassive black holes. NICMOS features more capable infrared detectors and gave astronomers their first clear view of the universe at near infrared wavelengths between 0.8 and 2.5 micrometers.

EVA 2 began at 10:25 pm, 14 February, and lasted seven hours, 27 minutes. Harbaugh and Tanner replaced a degraded Fine Guidance Sensor and a failed Engineering and Science Tape Recorder with new spares. Also installed was a new unit called the Optical Control Electronics Enhancement Kit, which further increased the capability of the Fine Guidance Sensor.[2] During this EVA astronauts noted cracking and wear on thermal insulation on the side of HST facing sun and in the direction of travel.[2]

EVA 3 began at 9:53 pm, 15 February, and lasted seven hours, 11 minutes. Lee and Smith removed and replaced a Data Interface Unit on Hubble, as well as a reel-to-reel Engineering and Science Tape Recorder with a new digital Solid State Recorder (SSR) that allowed simultaneous recording and playback of data.[2] Also changed out was one of four Reaction Wheel Assembly units that use spin momentum to move telescope toward a target and maintain it in a stable position. After this EVA, mission managers decided to add EVA 5 to repair the thermal insulation on HST.

EVA 4 began at 10:45 pm, 16 February, and lasted six hours, 34 minutes. Harbaugh and Tanner replaced a Solar Array Drive Electronics package which controls the positioning of Hubble's solar arrays. Also replaced covers over Hubble's magnetometers and placed thermal blankets of multi-layer material over two areas of degraded insulation around the light shield portion of the telescope just below the top of the observatory. Meanwhile, inside Discovery Horowitz and Lee worked on the middeck to fabricate new insulation blankets for HST.

Final space walk, EVA 5, lasted five hours, 17 minutes. Lee and Smith attached several thermal insulation blankets to three equipment compartments at the top of the Support Systems Module section of the telescope which contain key data processing, electronics and scientific instrument telemetry packages. STS-82 EVA total of 33 hours, 11 minutes is about two hours shy of total EVA time recorded on first servicing mission.

Discovery's maneuvering jets fired several times during mission to reboost telescope's orbit by eight nautical miles. Hubble redeployed on 19 Feb. at 1:41 am and is now operating at the highest altitude it has ever flown, a 335-nautical-mile (620 km) by 321-nautical-mile (594 km) orbit. Initial checkout of new instruments and equipment during mission showed all were performing nominally. Calibration of two new science instruments was to take place over a period of several weeks with first images and data anticipated in about eight to 10 weeks.

Wake-up calls

NASA began a tradition of playing music to astronauts during the Gemini program, which was first used to wake up a flight crew during Apollo 15.[4] Each track is specially chosen, often by their families, and usually has a special meaning to an individual member of the crew, or is applicable to their daily activities.[4][5]

Flight Day Song Artist/Composer
Day 2 "Magic Carpet Ride" Steppenwolf
Day 3 "These Are Days" 10,000 Maniacs
Day 4 "Two Princes" Spin Doctors
Day 5 "Higher Love" Steve Winwood
Day 6 "The Packerena" WMYX-FM
Day 7 "Shiny Happy People" R.E.M.
Day 8 "Dreams" The Cranberries
Day 9 "That Thing You Do" The Wonders
Day 10 "Five Hundred Miles Away From Home" Reba McEntire
Day 11 "Born to Be Wild" Steppenwolf

Summary of instruments exchange

See also

References

 This article incorporates public domain material from websites or documents of the National Aeronautics and Space Administration.

  1. 1 2 3 4 5 "STS-82 (82)". National Aeronautics and Space Administration. Retrieved 25 December 2011.
  2. 1 2 3 4 5 6 7 8 "Nasa - STS-82". National Aeronautics and Space Administration. Retrieved 25 December 2011.
  3. 1 2 Carré, D. J.; Bertrand, P. A. (1999). "Analysis of Hubble Space Telescope Reaction Wheel Lubricant". Journal of Spacecraft and Rockets. 36 (1): 109–113. doi:10.2514/2.3422.
  4. 1 2 Fries, Colin (25 June 2007). "Chronology of Wakeup Calls" (PDF). NASA. Retrieved 13 August 2007.
  5. ↑ NASA (11 May 2009). "STS-82 Wakeup Calls". NASA.
This article is issued from Wikipedia - version of the 11/26/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.