South African Class 10D 4-6-2

CSAR Class 10 4-6-2 1910
South African Class 10D 4-6-2

CSAR no. 1002, SAR no. 779, c. 1910
Type and origin
Power type Steam
Designer Central South African Railways
Builder American Locomotive Company
Serial number 46715
Model CSAR Class 10
Build date 1910
Total produced 1
Specifications
Configuration 4-6-2 (Pacific)
Driver 2nd coupled axle
Gauge 3 ft 6 in (1,067 mm) Cape gauge
Leading dia. 28 12 in (724 mm)
Coupled dia. 62 in (1,575 mm)
Trailing dia. 33 in (838 mm)
Tender wheels 33 12 in (851 mm)
Wheelbase 55 ft (16,764 mm)
  Engine 29 ft 8 in (9,042 mm)
  Leading 6 ft (1,829 mm)
  Coupled 11 ft 2 in (3,404 mm)
  Tender 16 ft 8 in (5,080 mm)
  Tender bogie 5 ft 4 in (1,626 mm)
Length:
  Over couplers 62 ft 7 in (19,075 mm)
Height 12 ft 9 716 in (3,897 mm)
Frame type Bar
Axle load 16 LT 10 cwt (16,760 kg)
  Leading 10 LT 19 cwt (11,130 kg)
  1st coupled 16 LT (16,260 kg)
  2nd coupled 16 LT 10 cwt (16,760 kg)
  3rd coupled 16 LT 3 cwt (16,410 kg)
  Trailing 12 LT 8 cwt (12,600 kg)
  Tender axle 11 LT 13 cwt 1 qtr (11,850 kg) av.
Adhesive weight 48 LT 13 cwt (49,430 kg)
Loco weight 72 LT (73,160 kg)
Tender weight 46 LT 13 cwt (47,400 kg) w/o
Total weight 118 LT 13 cwt (120,600 kg) w/o
Tender type 2-axle bogies
Fuel type Coal
Fuel capacity 10 LT (10.2 t)
Water cap 4,000 imp gal (18,200 l)
Firebox type Belpaire
  Firegrate area 35 sq ft (3.3 m2)
Boiler:
  Pitch 7 ft 8 in (2,337 mm)
  Diameter 5 ft 34 in (1,543 mm)
  Tube plates 18 ft 38 in (5,496 mm)
  Small tubes 132: 2 14 in (57 mm)
  Large tubes 18 5 14 in (133 mm)
Boiler pressure 170 psi (1,172 kPa)
Safety valve Ramsbottom
Heating surface 1,981 sq ft (184.0 m2)
  Tubes 1,848 sq ft (171.7 m2)
  Firebox 133 sq ft (12.4 m2)
Superheater:
  Type Cole
  Heating area 353 sq ft (32.8 m2)
Cylinders Two
Cylinder size 21 in (533 mm) bore
28 in (711 mm) stroke
Valve gear Walschaerts
Valve type Piston
Valve travel 5 12 in (140 mm)
Valve lap 1 in (25 mm)
Valve lead 14 in (6 mm)
Couplers Bell link-and-pin
Performance figures
Tractive effort 25,390 lbf (112.9 kN) @ 75%
Career
Operators Central South African Railways
South African Railways
Class CSAR Class 10, SAR Class 10D
Number in class 1
Numbers CSAR 1002, SAR 779
Delivered 1910
First run 1910
Withdrawn 1931
The 2nd coupled axle had flangeless wheels

The South African Railways Class 10D 4-6-2 of 1910 was a steam locomotive from the pre-Union era in the Transvaal.

In 1910, the Central South African Railways placed one American-built Class 10 4-6-2 Pacific type steam locomotive in service. When the South African Railways classification and renumbering took place in 1912, this locomotive was designated the sole member of Class 10D.[1][2][3][4]

Manufacturer

One 4-6-2 Pacific type passenger locomotive was ordered by the Central South African Railways (CSAR) from the American Locomotive Company (ALCO) in 1910. It was built to very much the same specifications as that of the CSAR Class 10-2 of that same year, which was designed by CSAR Chief Mechanical Engineer (CME) G.G. Elliot.[2][4][5]

The locomotive was slightly more powerful than the Class 10-2 and was designated Class 10 by the CSAR, with engine number 1002, along with the fifteen CSAR Class 10 4-6-2 locomotives which had been built by the North British Locomotive Company in 1904.[1][2][4][6]

Characteristics

The cylinders were arranged outside the 4 inches (102 millimetres) thick bar frames, while the piston valves, arranged above the cylinders, were actuated by Walschaerts valve gear. Reversing was effected by means of a screw gear. The locomotive had a Belpaire firebox and, instead of the usual deep bridle casting, was built with a shallow casting and frame under the firebox, which permitted all firebox stays to be removed without lifting the boiler from the frame.[2]

Cole superheater header

The locomotive was superheated, using the Cole double-header superheater system. It was somewhat similar to the Schmidt superheater system, except that the Cole type had two headers, arranged at either side of the smokebox, instead of one at the top.[7]

Each of the eighteen 5 14 inches (133 millimetres) diameter boiler flues contained four lengths of seamless steam pipes of 1 12 inches (38 millimetres) outside diameter, arranged in double pairs which were connected at the back ends by return bends, with the two pairs connected to each other at the front by another return bend. This forced the steam to traverse the entire four pipe lengths before entering the steam chests. The two free front ends of each such foursome of pipes were bent around to meet the steam headers. This design of superheater produced a superheat of from 175 to 250 degrees Fahrenheit (79 to 121 degrees Celsius) above saturation temperature.[7]

South African Railways

When the Union of South Africa was established on 31 May 1910, the three Colonial government railways (Cape Government Railways, Natal Government Railways and CSAR) were united under a single administration to control and administer the railways, ports and harbours of the Union. Although the South African Railways and Harbours came into existence in 1910, the actual classification and renumbering of all the rolling stock of the three constituent railways required careful planning and was only implemented with effect from 1 January 1912.[3][8]

In 1912, the sixteen CSAR Class 10 locomotives were renumbered on the South African Railways (SAR) roster. The fifteen older British-built locomotives retained their Class 10 designation on the SAR roster, but the ALCO-built one was designated the sole member of Class 10D and renumbered 779.[2][3][9]

Service

The Class 10D was placed in service on fast passenger work in the Transvaal and later in the Orange Free State. It spent its last working years at Bloemfontein, until it was withdrawn from service in 1931 and scrapped.[1][4]

References

  1. 1 2 3 Holland, D.F. (1971). Steam Locomotives of the South African Railways, Volume 1: 1859-1910 (1st ed.). Newton Abbott, Devon: David & Charles. pp. 138–139. ISBN 978-0-7153-5382-0.
  2. 1 2 3 4 5 Espitalier, T.J.; Day, W.A.J. (1945). The Locomotive in South Africa - A Brief History of Railway Development. Chapter VI - Imperial Military Railways and C.S.A.R. (Continued). South African Railways and Harbours Magazine, March 1945. p. 183.
  3. 1 2 3 Classification of S.A.R. Engines with Renumbering Lists, issued by the Chief Mechanical Engineer's Office, Pretoria, January 1912, pp. 9, 12, 15, 35 (Reprinted in April 1987 by SATS Museum, R.3125-6/9/11-1000)
  4. 1 2 3 4 Paxton, Leith; Bourne, David (1985). Locomotives of the South African Railways (1st ed.). Cape Town: Struik. p. 53. ISBN 0869772112.
  5. "Powerful Freight and Passenger Locomotives for a Narrow Gauge Railway". American Engineer and Railroad Journal: 192–194. May 1910. Retrieved 31 December 2012.
  6. Durrant, A E (1989). Twilight of South African Steam (1st ed.). Newton Abbott, London: David & Charles. pp. 8–10. ISBN 0715386387.
  7. 1 2 Espitalier, T.J.; Day, W.A.J. (1944). The Locomotive in South Africa - A Brief History of Railway Development. Chapter III - Natal Government Railways (Continued). South African Railways and Harbours Magazine, August 1944. pp. 591-594, 599.
  8. The South African Railways - Historical Survey. Editor George Hart, Publisher Bill Hart, Sponsored by Dorbyl Ltd., Published c. 1978, p. 25.
  9. Holland, D.F. (1972). Steam Locomotives of the South African Railways, Volume 2: 1910-1955 (1st ed.). Newton Abbott, Devon: David & Charles. p. 140. ISBN 978-0-7153-5427-8.
Wikimedia Commons has media related to South African Class 10D (4-6-2).
This article is issued from Wikipedia - version of the 8/18/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.