South African Class S2 0-8-0

South African Class S2 0-8-0

No. 3728 in the Table Bay yard, August 1973
Type and origin
Power type Steam
Designer South African Railways
(L.C. Grubb)
Builder Friedrich Krupp AG
Serial number 2966-3065
Model Class S2
Build date 1952-1953
Total produced 100
Specifications
Configuration 0-8-0 (Eight-coupled)
Driver 3rd coupled axle
Gauge 3 ft 6 in (1,067 mm) Cape gauge
Coupled dia. 48 in (1,219 mm)
Tender wheels 34 in (864 mm)
Wheelbase 51 ft 2 58 in (15,611 mm)
  Engine 12 ft 9 in (3,886 mm)
  Tender 24 ft 7 14 in (7,499 mm)
  Tender bogie 8 ft 8 in (2,642 mm)
Length:
  Over couplers 63 ft 3 34 in (19,298 mm)
Height 12 ft 4 in (3,759 mm)
Frame type Cast
Axle load 13 LT (13,210 kg)
  1st coupled 13 LT (13,210 kg)
  2nd coupled 12 LT 6 cwt (12,500 kg)
  3rd coupled 11 LT 4 cwt 3 qtr (11,420 kg)
  4th coupled 11 LT 2 cwt 3 qtr (11,320 kg)
  Tender bogie Bogie 1: 26 LT 15 cwt 3 qtr (27,220 kg)
Bogie 2: 26 LT 12 cwt 1 qtr (27,040 kg)
  Tender axle 8 LT 18 cwt 2 qtr (9,068 kg)
Adhesive weight 47 LT 13 cwt 2 qtr (48,440 kg)
Loco weight 47 LT 13 cwt 2 qtr (48,440 kg)
Tender weight 54 LT 8 cwt (55,270 kg)
Total weight 102 LT 1 cwt 2 qtr (103,700 kg)
Tender type MY1 (Buckeye 3-axle bogies)
Fuel type Coal
Fuel capacity 8 LT (8.1 t)
Water cap 4,200 imp gal (19,100 l)
Firebox type Round-top
  Firegrate area 30 sq ft (2.8 m2)
Boiler:
  Pitch 8 ft 4 in (2,540 mm)
  Diameter 4 ft 6 78 in (1,394 mm)
  Tube plates 13 ft 5 38 in (4,099 mm)
  Small tubes 91: 2 in (51 mm)
  Large tubes 18: 5 12 in (140 mm)
Boiler pressure 195 psi (1,344 kPa)
Safety valve Pop
Heating surface 1,092 sq ft (101.5 m2)
  Tubes 979 sq ft (91.0 m2)
  Firebox 113 sq ft (10.5 m2)
Superheater:
  Heating area 330 sq ft (31 m2)
Cylinders Two
Cylinder size 18 in (457 mm) bore
26 in (660 mm) stroke
Valve gear Walschaerts
Valve type Piston
Couplers AAR knuckle
Performance figures
Tractive effort 25,300 lbf (113 kN) @ 75%
Career
Operators South African Railways
Class Class S2
Number in class 100
Numbers 3701-3800
Delivered 1952-1953
First run 1952
Withdrawn 1985
The 3rd coupled axle had flangeless wheels

The South African Railways Class S2 0-8-0 of 1952 was a steam locomotive.

In 1952 and 1953, the South African Railways placed one hundred Class S2 shunting steam locomotives with a 0-8-0 wheel arrangement in service.[1][2]

Design specifications

L.C. Grubb

By 1952, the need arose for shunting locomotives with a light axle load for harbour work, where most of the trackwork was laid with light rail. Under the direction of L.C. Grubb, Chief Mechanical Engineer of the South African Railways (SAR) from 1949 to 1954, specifications were prepared for a light locomotive with the 0-8-0 wheel arrangement which had already been proven successful with the Classes S and S1 shunting engines. To keep the total weight of the engine and tender down to approximately 100 long tons (101.6 tonnes), it was to be equipped with the Watson Standard no. 1 boiler, the smallest of the standard boilers.[1][2]

Manufacturer

When tenders were called for, a number of firms responded, but all except one stated that it would not be possible to construct the locomotive within the stipulated weight. Only the firm of Friedrich Krupp AG of Essen in Germany undertook to build the locomotives to the required specifications.[1]

When design work commenced after the signing of the contract, however, it was discovered that the other tendering firms had been correct and that the locomotives could not be built within the specified weight limit, if the specifications were to be adhered to. It was eventually agreed that Krupp should design a suitable smaller boiler which would bring the locomotive's weight down to a level which would be in line with the stipulated maximum. The end result was an engine which had the appearance of a Cape gauge locomotive with a narrow gauge boiler, particularly when viewed from the front.[1][2]

One hundred Class S2 locomotives were subsequently built by Krupp and delivered in 1952 and 1953, numbered in the range from 3701 to 3800. Even with the smaller Krupp-designed boiler, the locomotive's eventual working order weight was still more than 2 long tons (2.0 tonnes) over the desired maximum.[1][2][3]

Characteristics

The locomotive had Walschaerts valve gear and was superheated. Its cast steel frame was a single casting with separately attached cylinders. As built, the third coupled axle had flangeless wheels to negotiate the tight curves found in docks.[1]

Buckeye bogie

Like the Class 24 and the last batch of the Class 19D, the Class S2 had a tank wagon type tender, similar in appearance to the American Vanderbilt type tender, with cylindrical water tanks and commonly known as a Torpedo tender. Its Type MY1 tender also rode on three-axle Buckeye bogies to reduce the axle load, but was much shorter than the Type MX tender of the Class 19D and with a different coal bunker top design than that of the Type MY tender of the Class 24. As was done with the tenders of the Classes S and S1, the top sides of the coal bunker were scalloped out to improve the crew's rearward field of vision.[2][3]

Service

Most of the Class S2 locomotives were placed in shunting service in the Durban, Cape Town and Port Elizabeth harbours, where they replaced a variety of aged 4-6-0, 4-8-0 and 4-8-2T locomotives. About twenty were also allocated to yards on the Witwatersrand and in the Eastern Transvaal, where they were employed in light general shunting.[2][4]

One Class S2 locomotive, stationed at Capital Park in Pretoria, was painted in blue livery to be used for the shunting of Blue Train stock, until it was eventually replaced by a Class 19D locomotive, which was also painted blue. During 1981, four Class S2 locomotives were hired to Mozambique for dock shunting in Maputo.[4]

All but one were withdrawn from service in 1982. The last Class S2 locomotive in service was the shed pilot at Waterval Boven, which remained in service until 1985. In Cape Town and Durban, they were replaced by Class 36-000 and Class 36-200 light general purpose diesel-electric locomotives, but in Port Elizabeth their initial replacements were older steam locomotives of larger capacity.[2][4]

Commemoration

A 10c postage stamp depicting a Class S2 locomotive was one of a set of four commemorative postage stamps which were issued by the South African Post Office on 27 April 1983, to commemorate the steam locomotives of South Africa, which were rapidly being withdrawn from service at the time. The artwork and stamp design was by the noted stamp designer and artist Hein Botha.[5]

The particular locomotive depicted was no. 3781. The outline of a traditional SAR locomotive number plate was used as a commemorative cancellation for De Aar on the date of issue.[5]

Illustration

The main picture and the following illustrate different views of the Class S2 locomotive and its Type MY1 tender. One locomotive, no. 3706, was preserved in the Outeniqua Transport Museum in George.

References

  1. 1 2 3 4 5 6 Holland, D.F. (1972). Steam Locomotives of the South African Railways, Volume 2: 1910-1955 (1st ed.). Newton Abbott, Devon: David & Charles. pp. 108–109. ISBN 978-0-7153-5427-8.
  2. 1 2 3 4 5 6 7 Paxton, Leith; Bourne, David (1985). Locomotives of the South African Railways (1st ed.). Cape Town: Struik. p. 81. ISBN 0869772112.
  3. 1 2 South African Railways and Harbours Locomotive Diagram Book, 2'0" & 3'6" Gauge Steam Locomotives, 15 August 1941, as amended
  4. 1 2 3 Durrant, A E (1989). Twilight of South African Steam (1st ed.). Newton Abbott, London: David & Charles. pp. 122–123. ISBN 0715386387.
  5. 1 2 Philatelic Bulletin 176, issued by Philatelic Services and INTERSAPA, 1983
Wikimedia Commons has media related to South African Class S2 (0-8-0).
This article is issued from Wikipedia - version of the 7/9/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.